[Free] 2018(Jan) EnsurePass Testinsides LPI 117-202 Dumps with VCE and PDF 121-130

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan LPI Official New Released 117-202
100% Free Download! 100% Pass Guaranteed!

Linux Networking Administration

Question No: 121

Which option must be used with ifconfig, to also see interfaces that are down?

  1. -d

  2. -a

  3. -all

  4. -down

  5. None.

Answer: A

Question No: 122

What is the command to add another IP address to an interface that already has (at least) one IP address?

A. ifconfig eth0:1

B. ifconfig eth0

C. ipconfig eth0:1

D. ipconfig eth0

Answer: A

Question No: 123

The command route shows the following output:

Ensurepass 2018 PDF and VCE

Which of the following statements is correct?

  1. The network is not a valid route.

  2. The host is temporarily down.

  3. The host route is rejected by the kernel.

  4. The quot;!H quot; signals that traffic to the host is dropped.

  5. The network path to the host is not available.

Answer: C

Question No: 124

A network client has an ethernet interface configured with an IP address in the subnet

This subnet has a router, with the IP address, that connects this subnet to the Internet.

What needs to be done on the client to enable it to use the router as its default gateway?

  1. Run route add default gw eth1.

  2. Run route add gw eth1.

  3. Run ifconfig eth0 defaultroute

  4. Add quot;defaultroute; to /etc/resolv.conf.

  5. Run route add defaultgw= if=eth0.

Answer: A

Question No: 125

A server with 2 network interfaces, eth0 and eth1, should act as a router. eth0 has the IP address in the subnet and eth1 has the IP address in the subnet

The routing table looks fine, but no data is traversing the networks. Which TWO of the following need to be done?

  1. Enable IP forwarding with echo quot;1quot; gt; /proc/sys/net/ipv4/ip_forward

  2. Add new firewall chains to handle inbound amp; outbound traffic on both interfaces.

  3. Reconfigure the firewall rules to allow traffic to traverse the networks.

  4. The routing table needs to be restarted, for the changes to take effect.

  5. The server needs to be restarted, for the changes to take effect.

Answer: A,C

Question No: 126

What command is used to add a route to the network via

A. route add – network netmask gw

B. route add – net gw

C. route add – network

D. route add – net netmask

E. route add – net netmask gw

Answer: E

Question No: 127

Which of the following sentences is true, when using the following /etc/pam.d/login file?


auth required /lib/security/pam_securetty.so auth required /lib/security/pam_nologin.so

auth sufficient /lib/security/pam_unix.so shadow nullok md5 use_authtok auth required /lib/security/pam_ldap.so use_first_pass

account sufficient /lib/security/pam_unix.so account required /lib/security/pam_ldap.so password required /lib/security/pam_cracklib.so

password sufficient /lib/security/pam_unix.so nullok use_authtok md5 shadow password required /lib/security/pam_ldap.so use_first_pass

session optional /lib/security/pam_console.so session sufficient /lib/security/pam_unix.so session required /lib/security/pam_ldap.so

  1. All users will be authenticated against the LDAP directory

  2. This is the only file needed to configure LDAP authentication on Linux

  3. Only local users will be able to log in, when the file/etc/nologin exists

  4. Ordinary users will be able to change their password to be blank

  5. If the control flags for auth were changed to required, local users wouldn#39;t be able to log


Answer: D

Question No: 128

LDAP-based authentication against a newly-installed LDAP server does not work as expected. The file /etc/pam.d/login includes the following configuration parameters. Which of them is NOT correct?

  1. password required /lib/security/pam_ldap.so

  2. auth sufficient /lib/security/pam_ldap.so use_first_pass

  3. account sufficient /lib/security/pam_ldap.so

  4. password required /lib/security/pam_pwdb.so

  5. auth required /lib/security/pam_ldap.so

Answer: E

Question No: 129

What is the advantage of using SASL authentication with OpenLDAP?

  1. It can prevent the transmission of plain text passwords over the network.

  2. It disables anonymous access to the LDAP server.

  3. It enables the use of Access Control Lists.

  4. It allows the use of LDAP to authenticate system users over the network.

  5. All of the above.

Answer: A

Question No: 130

In a PAM configuration file, which of the following is true about the required control flag?

  1. If the module returns success, no more modules of the same type will be invoked

  2. The success of the module is needed for the module-type facility to succeed. If it returns a failure, control isreturned to the calling application

  3. The success of the module is needed for the module-type facility to succeed.However, all remainingmodules of the same type will be invoked.

  4. The module is not critical and whether it returns success or failure is not important.

  5. If the module returns failure, no more modules of the same type will be invoked

Answer: C

100% Ensurepass Free Download!
Download Free Demo:117-202 Demo PDF
100% Ensurepass Free Guaranteed!
117-202 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No